MacDon M205 Operators Manual - Manual (Page 386)

MAINTENANCE AND SERVICING
Replacing Bulbs in Red and Amber Lights
To replace bulbs in red and amber lights, follow these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Shut down engine and remove key. Turn lights OFF.
NOTE:
Hold onto the handholds (A) on the cab front
corners and stand on the header anti-slip strips,
or stand on the maintenance platform when
accessing the red and amber lights.
Figure 5.174: Cab Forward Handholds
2. Remove two screws (A) from lens and remove lens.
3. Push and twist light bulb to remove from socket.
4. Install new bulb in socket ensuring that bulb base is
properly engaged in socket.
• Use Bulb Trade #1157 for red tail lights
• Use Bulb Trade #1156 for amber lights
5. Reinstall lens with screws (B).
Figure 5.175: Red and Amber Lights
Replacing Red Tail Lights (if installed)
To replace the red tail lights, follow these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Shut down engine and remove key. Turn lights OFF.
169887 370 Revision A