MacDon M205 Operators Manual - Manual (Page 212)

OPERATION
Programming the Return to Cut Feature
Figure 4.87: Operator Console
Program the RETURN TO CUT (RTC) feature as follows:
CAUTION
Check to be sure all bystanders have cleared the area.
1. Start and windrower and engage the header.
2. Set RETURN TO CUT switch (A) to OFF (indicator light is OFF).
3. Adjust the header to the desired cutting height with the HEADER UP (B) or HEADER DOWN (C) switches on
the ground speed lever (GSL). The cab display module (CDM) displays between 00.0 and 10.0 at (D).
4. Adjust the header angle with the HEADER TILT UP (E) or HEADER TILT DOWN (F) switches on the GSL. The
CDM displays between 00.0 and 10.0. This step is not required when height only has been preselected.
5. Press the RETURN TO CUT switch (A) on the CDM. The indicator light will illuminate and the settings are now
programmed into the windrower control module (WCM).
169887 196 Revision A