MacDon M205 Operators Manual - Manual (Page 149)

OPERATOR’S STATION
Activating the Hydraulic Purge using the Cab Display Module (CDM)
The hydraulic purge removes air from the hydraulic pump system after it has been repaired or changed.
NOTE:
Engine MUST be running to perform this procedure.
1. Start the engine. Refer to Starting the Engine, page
152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
Figure 3.179: CDM Programming Buttons
3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select Yes. Press SELECT (B).
Figure 3.180: Selecting Diagnostic Functions
5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (A) arrow to select YES. Press SELECT (B).
• ACTIVATE HEADER HT is displayed on the
upper line.
• DOWN/UP is displayed on the lower line.
Figure 3.181: Selecting Activate Functions
169887 133 Revision A