MacDon M205 Operators Manual - Manual (Page 270)

OPERATION
Setting Draper Index
Figure 4.221: Operator Console
CAUTION
Check to be sure all bystanders have cleared the area.
Set draper index as follows:
IMPORTANT:
Draper Index can only be adjusted while operating at a ground speed faster than minimum draper speed plus
header index value.
1. Engage header.
2. Set HEADER INDEX switch (B) to ON.
3. Press DISPLAY SELECTOR (E) on the ground speed lever (GSL) to display DRAPER INDX 16 at (A) on the cab
display module (CDM).
4. Press DRAPER FAST (C) or SLOW (D) on the CDM until display (A) shows ##.## ##.# DRAP IND with the
desired index value.
• The displayed value (##.##) = draper speed (mph or km/h 17 )
• The displayed value (##.#) = the index value
16. DRAPER INDX will only be displayed when operating at a ground speed faster than minimum draper speed plus the header
index value.
17. Depending on CDM programming.
169887 254 Revision A