MacDon M205 Operators Manual - Manual (Page 105)

OPERATOR’S STATION
5. Press SELECT (D) until BUZZER VOLUME is
displayed on the upper line.
• Previous setting is displayed on the lower line.
6. Press left (B) or right (C) arrows to adjust
buzzer volume.
7. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.
Figure 3.76: Adjusting Buzzer Volume
Adjusting the Cab Display Backlighting
The backlighting feature brightens the display screen helping you read the cab display module (CDM) in low
light situations.
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
Figure 3.77: CDM Programming Buttons
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? is displayed on the
upper line.
Figure 3.78: Selecting Cab Display Setup
169887 89 Revision A