MacDon M205 Operators Manual - Manual (Page 121)

OPERATOR’S STATION
7. Press right (C) arrow to select YES. Press
SELECT (D).
• DWA AUTO UP/DOWN ? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
NOTE:
If the Operator selects YES, the DWA Auto-Up function
will be activated by the GSL Reel Fore-Aft button.
8. Press right (C) arrow to select YES. Press
SELECT (D).
9. Press PROGRAM to exit Programming Mode or press
SELECT to proceed to next WINDROWER SETUP
action. Figure 3.112: DWA Auto Up/Down
Setting the Auto Raise Height
For more information on the Auto Raise Height feature, refer to 4.4.8 Auto Raise Height, page 198 .
NOTE:
Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.113: CDM Programming Buttons
169887 105 Revision A