MacDon M205 Operators Manual - Manual (Page 255)

OPERATION
CAUTION
Check to be sure all bystanders have cleared the area.
2. Start the engine and activate HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
Figure 4.191: GSL
3. If necessary, relocate the clevis pin (A) at the frame
linkage as required to raise the center-link (B), so that
the hook is above the attachment pin on the header.
Figure 4.192: Hydraulic Center-Link without
Self-Alignment
4. Slowly drive windrower forward so that feet (A) on
windrower enter boots (B) on the header. Continue to
drive slowly forward until feet engage the boots and
header nudges forward.
Figure 4.193: Header Boots
169887 239 Revision A