MacDon M205 Operators Manual User Manual
Page 322
6. Adjust switch (A) as follows:
a. Loosen nuts (B) and rotate switch on support
sufficiently so that GSL will contact switch lever (C)
and push in the plunger (D).
b. Tighten nuts (B).
Figure 5.46: Switch Lever
7. If necessary, replace switch as follows:
a. Disconnect wiring harness (A) at connector.
b. Remove nuts and screws (B) and remove the old
switch (C).
c. Install the new switch (C) on the support and
secure with nuts and screws (B).
d. Connect harness (A) to console wiring.
Figure 5.47: GSL Switch Lever
8. Position the switch support plate (B) inside the console
and secure with rubber nuts (A).
NOTE:
For clarity, console in the image was made
transparent to show the switch support plate (B).
9. Check operation of the new switch.
Figure 5.48: Console (Transparent)
169887
306
Revision A