Danger – MacDon M205 Operators Manual User Manual
Page 223
19. Connect header drive hoses (A) and electrical
harness (B) to header. Refer to the draper header
operator’s manual.
Figure 4.109: Header Drive Hoses and Harness
20. Connect reel hydraulics (A) at right-hand side
of windrower.
Refer to the draper header
operator’s manual.
Figure 4.110: Reel Hydraulics
Attaching a D-Series Header: Hydraulic Center-Link without Self-Alignment
NOTE:
This topic assumes that draper header boots have already been attached to the windrower lift linkage. If that is
not the case, refer to
4.6.1 Attaching Header Boots, page 248
.
To attach a D-Series header to a windrower equipped with a hydraulic center-link without the self-alignment kit, follow
these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
169887
207
Revision A