MacDon M205 Operators Manual - Manual (Page 142)

OPERATOR’S STATION
7. Press left (A) or right (B) arrow to cycle through list of
header types.
8. When desired header type is displayed press
SELECT (C).
• EXIT FORCE HEADER? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
9. Press right arrow (B) to select YES. Press SELECT (C).
Proceed to next DIAGNOSTIC MODE or press
PROGRAM to exit programming mode.
Figure 3.162: Selecting Header Type
3.18.12 Troubleshooting Header Problems
You can test individual parts of the header as part of a troubleshooting routine.
Testing the Header Up/Down Function using the Cab Display Module (CDM)
NOTE:
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
• Engine MUST be running to perform this procedure.
1. Start the engine. Refer to Starting the Engine, page
152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode. Press
SELECT (C).
• WINDROWER SETUP? is displayed on the
upper line.
Figure 3.163: CDM Programming Buttons
169887 126 Revision A