MacDon M205 Operators Manual - Manual (Page 393)

MAINTENANCE AND SERVICING
Replacing the Cabin Dome Light
To replace a cabin dome light, follow these steps:
1. Shut down engine.
2. Remove two screws (A) from the dome light assembly
and remove the assembly.
3. Disconnect the old dome light assembly from the
wiring harness.
4. Connect the new dome light MD #183413 to the
wiring harness.
5. Install the new dome light with two screws (A).
Figure 5.187: Cabin Dome Light
Replacing the Ambient Light Fixture
To replace the ambient light fixture, follow these steps:
1. Shut down engine.
2. Locate the ambient light fixture (A) in the roof liner.
Figure 5.188: Ambient Light Fixture
3. Push against tabs (A) with a screwdriver and pull
ambient light fixture out of cab roof.
4. Remove wires from connectors (B).
5. Connect wires to new light fixture.
6. Push into place in cab roof until tabs hold fixture
in place.
Figure 5.189: Ambient Light Fixture
169887 377 Revision A