MacDon M205 Operators Manual - Manual (Page 269)

OPERATION
Setting Draper Minimum Speed
Figure 4.220: Operator Console
CAUTION
Check to be sure all bystanders have cleared the area.
Set draper minimum speed as follows:
IMPORTANT:
Set the minimum draper speed while stationary with the ground speed lever (GSL) in the N-DETENT position.
1. Engage header.
2. Set HEADER INDEX (B) switch to ON.
3. Press DISPLAY SELECTOR button (E) until display (A) shows ##.## DRAPER MIN.
The displayed value (##.##) = draper speed (mph or km/h 15 ).
4. Use the FAST (C) and SLOW (D) buttons to set the desired minimum draper speed.
15. Depending on cab display module (CDM) programming.
169887 253 Revision A