MacDon M205 Operators Manual - Manual (Page 112)

OPERATOR’S STATION
4. Press right (B) arrow to select Yes. Press SELECT (C).
• TO CALIBRATE SELECT is displayed in upper line.
5. Press left (A) or right (B) arrow until HEADER FLOAT
is displayed on the lower line. Press SELECT (C).
• CALIBRATING FLOAT is displayed on the
upper line.
• PRESS FLOAT + TO START is displayed on the
lower line.
CAUTION
Check to be sure all bystanders have cleared the area.
Figure 3.92: Calibrate Header Float
6. Press and hold the FLOAT + (A) button on the CDM.
• CALIBRATING FLOAT is displayed on the
upper line.
• FLOAT ( + ) HOLD is displayed on the lower line.
NOTE:
The word HOLD will flash during calibration. FLOAT
(+) DONE will display on the lower line once calibration
is complete.
7. Release the FLOAT + (A) button.
• CALIBRATING FLOAT is displayed on the
upper line.
• FLOAT ( - ) HOLD is displayed on the lower line.
Figure 3.93: Calibrate Positive Header Float
8. Press and hold FLOAT - (A) button on CDM.
• CALIBRATING FLOAT is displayed on the
upper line.
• FLOAT ( - ) HOLD is displayed on the lower line.
NOTE:
The word HOLD will flash during calibration. HDR
FLOAT COMPLETE will display on the lower line once
calibration is complete.
9. Release FLOAT - (A) button.
• TO CALIBRATE SELECT is displayed on the
upper line.
• HEADER FLOAT is displayed on the lower line.
Figure 3.94: Calibrate Negative Header Float
10. Press right arrow to select next header sensor
calibration or STOP & EXIT. Press SELECT
Refer to
Calibrating the Header Height Sensor, page
91 or Calibrating the Header Tilt Sensor, page 93 .
11. Press PROGRAM to exit Programming Mode.
169887 96 Revision A