MacDon M205 Operators Manual - Manual (Page 136)

OPERATOR’S STATION
6. Press left (B) or right (C) arrow to cycle between control
switch lock outs. The displayed control switches are as
follows:
• HEADER TILT
• HEADER FLOAT
• REEL FORE/AFT
• DRAPER SPEED
• AUGER SPEED
• KNIFE SPEED
• DISK SPEED
• REEL SPEED
NOTE:
Not all control locks apply to every header.
7. Press SELECT.
• EXIT VIEW LOCKOUTS? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
8. Press right to select YES.
9. Press PROGRAM to exit Programming Mode or
press SELECT to proceed to next WINDROWER
SETUP action.
Figure 3.148: Cycle between Control Locks
3.18.11 Troubleshooting Windrower Problems
Displaying the Windrower and Engine Error Codes
NOTE:
Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 202 .
1. Start the engine.
For more information, refer to Starting the Engine,
page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode. Press
SELECT (C).
• WINDROWER SETUP? is displayed on the
upper line.
3. Press SELECT (C) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is displayed on the lower line.
Figure 3.149: CDM Programming Buttons
169887 120 Revision A