MacDon M205 Operators Manual - Manual (Page 120)

OPERATOR’S STATION
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.109: CDM Programming Buttons
4. Press SELECT (B) until DWA INSTALLED? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (A) arrow to select YES. Press SELECT (B).
Figure 3.110: Activate DWA Controls
6. SWAP DWA CONTROLS? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
NOTE:
This step swaps the DWA controls from the console
switch to the ground speed lever (GSL) reel fore-aft
buttons.
Figure 3.111: Swap DWA Controls
169887 104 Revision A