MacDon M205 Operators Manual - Manual (Page 139)

OPERATOR’S STATION
7. Press left (B) arrow to enable a sensor. Press right (C)
arrow to disable sensor. Press SELECT (D) to confirm
selection and move on to next sensor.
The following sensors are available:
• HEADER HT SENSOR
• HEADER TILT SENSOR
• KNIFE SPEED SENSOR
• REEL SPEED SENSOR
• HEADER FLOAT SENSOR
• OVERLOAD PRESSURE 10
• HYD OIL TEMP SENSOR
When sensors have been modified, press SELECT (D)
to display the EXIT SENSOR SETUP? selection.
Figure 3.155: Selecting Header Senors
8. Press right arrow to select YES. Press SELECT.
9. Press PROGRAM to exit Programming Mode or press
SELECT to proceed to next DIAGNOSTIC MODE.
Displaying Header Sensors Input Signals
You can display individual sensor input signals in the event of a malfunction or as part of a troubleshooting routine.
NOTE:
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
Figure 3.156: CDM Programming Buttons
10. Requires installation of optional Pressure Sensor (MD #5574).
169887 123 Revision A