MacDon M205 Operators Manual - Manual (Page 114)

OPERATOR’S STATION
Setting the Rotary Disc Overload Speed
NOTE:
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
• Recommended Disc Overload Speed is 75% of Disc Speed. For more information refer to the Rotary Disc
Header Operator’s Manual to determine proper overload speed.
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
Figure 3.97: CDM Programming Buttons
4. Press SELECT (D) until DISK OVERLOAD SPD? is
displayed on the upper line.
• The current overload speed is displayed on the
lower line.
NOTE:
-300 rpm is default setting. Range is -500 to -100 rpm.
5. Press left (B) or right (C) arrows to set disc overload
speed. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.98: Setting Disc Overload Speed
Setting the Header Knife Speed
NOTE:
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
• For more information, refer to 4.6.7 Knife Speed, page 256 to determine proper knife speed.
169887 98 Revision A