MacDon M205 Operators Manual - Manual (Page 135)

OPERATOR’S STATION
6. Press SELECT (D) until HEADER TILT is displayed on
the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7. Press left (B) arrow to enable HEADER TILT
control switch.
Press right (C) arrow to lock HEADER TILT
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.145: Set Header Tilt Control Lock
3.18.10 Displaying Activated Cab Display Lock Outs
Displaying the activated control locks allows you to quickly determine which controls are locked on the cab
display module (CDM).
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.146: CDM Programming Buttons
4. Press SELECT (B) until VIEW CONTROL LOCKS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (A) arrow to select YES. Press SELECT (B).
HEADER TILT is displayed on the upper line.
• The control switch status is displayed on the lower
line. The hours displayed indicate when a switch
was enabled or locked.
Figure 3.147: View Control Locks
169887 119 Revision A