MacDon M205 Operators Manual - Manual (Page 129)

OPERATOR’S STATION
6. Press SELECT (D) until HEADER FLOAT is displayed
on the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7. Press left (B) arrow to enable HEADER FLOAT
control switch.
Press right (C) arrow to lock HEADER FLOAT
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.130: Set Header Float Control Lock
Activating the Draper Speed Control Lock Out
NOTE:
• This procedure is for draper headers only.
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.131: CDM Programming Buttons
169887 113 Revision A