MacDon M205 Operators Manual - Manual (Page 254)

OPERATION
16. Connect header drive hoses (A) and electrical
harness (B) to header. Refer to the rotary disc header
operator’s manual.
Figure 4.188: Header Drive Hoses and Harness
Attaching an R-Series Header: Hydraulic Center-Link without Self-Alignment
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Remove hairpin (B) from clevis pin (A) and remove pin
from left and right header boots (C) on header.
Figure 4.189: Header Boot
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to windrower, ensure that float engagement
pin is installed in storage location (B) and NOT
installed at hole location (A).
Figure 4.190: Header Lift Linkage
169887 238 Revision A