MacDon M205 Operators Manual - Manual (Page 146)

OPERATOR’S STATION
1. Start the engine. Refer to Starting the Engine, page
152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
Figure 3.171: CDM Programming Buttons
3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select Yes. Press SELECT (B).
Figure 3.172: Selecting Diagnostic Functions
5. Press SELECT (D) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (C) arrow to select YES. Press
SELECT (D).
Figure 3.173: Selecting Activate Functions
169887 130 Revision A