MacDon M205 Operators Manual - Manual (Page 344)

MAINTENANCE AND SERVICING
1. Stop the engine and remove the key.
2. Open the hood, refer to 5.4.3 Opening Hood (Highest
Position), page 289 .
3. On the bottom of the fuel tank, locate the fuel supply
valve (A) and move it to the closed position.
Figure 5.89: Fuel System
4. Locate the primary fuel filter (A) on the right
cab-forward side of the windrower.
NOTE:
Bottom part of the image made transparent to
show location of the primary filter.
Figure 5.90: Fuel Filter Locations
5. Clean around the primary filter (A) head.
6. Disconnect the water in fuel (WIF) sensor (B) from
bottom of filter.
7. Turn drain valve (C) by hand counterclockwise until
draining occurs, and drain filter into a container.
8. Remove filter (A) with a filter wrench.
9. Clean gasket mating surface.
Figure 5.91: Fuel System
169887 328 Revision A