MacDon M205 Operators Manual - Manual (Page 470)

CAB DISPLAY MODULE (CDM) ERROR CODES
Codes CDM Display Description
E31 E131 BYPASS VALVE P52 Bypass valve solenoid P52 fault detected
E32 E132 HEADER UP/DOWN P57 Header up / down solenoid P57, fault detected
E33 E133 SCREEN CLEANERS Screen cleaner output fault detected
E34 E134 RIGHT STOP LAMP Right stop lamp output fault detected
E35 E135 LEFT STOP LAMP Left stop lamp output fault detected
E36 E136 RIGHT TURN LAMP Right turn lamp output fault detected
E37 E137 LEFT TURN LAMP Left turn lamp output fault detected
E38 E138 MAIN DRIVE Main header drive solenoid P106 fault detected
E39 E139 LOW RANGE P61 Low range solenoid P61 fault detected
E40 E140 HIGH RANGE P60 High range solenoid P60 fault detected
E41 E141 REEL AFT Reel aft solenoid P55, P59, fault detected
E42 E142 REEL FORE Reel fore solenoid P55, P59, fault detected
E43 E143 REEL UP/DOWN P58 Reel up / down solenoid P58, P52, P62 fault detected
E44 E144 FLOAT RHS P64 RHS float solenoid P64, fault detected
E45 E145 FLOAT LHS P63 LHS float solenoid P63, fault detected
E46 SENSOR VOLTS HIGH WCM’s 9V sensor voltage output high (wire CH5)
E47 SENSOR VOLTS LOW WCM’s 9V sensor voltage output low (wire CH5)
E48 WCM OVER TEMP WCM over temp fault
E49 WCM LOW TEMP WCM low temp fault
E50 BATT+ OUT OF RANGE System voltage above 15.5 VDC
E51 DISK DRIVE PWM P68 Disk header drive solenoid P68 fault detected
E52
E53 E153 REVERSER P71 Optional reverser—solenoid P71 fault detected
E54
E55 DISK SPD OVERLOAD Low disk speed detected < setpoint
Error codes E56 to E63 not allocated
E64
E65 KNIFE SPD OVERLOAD Low knife speed detected < setpoint
E66 ##.# LOW VOLTS Low system voltage <11.5 VDC
E67 TRANS OIL PRESSURE
Supercharge pressure low (switch 202 on hydraulic
schematic)
E68 HYDRAULIC OIL HOT Oil tank temp >230°F/110°C
E69 ENGINE AIR FILTER Engine air filter plugged
E70 HYDRAULIC FILTER
Hydraulic filter pressure too high (switch 227 on hydraulic
schematic)
E71 LOW HYDRAULIC OIL
Low hydraulic oil level sensor tripped (switch 225 on hydraulic
schematic)
169887 454 Revision A