MacDon M205 Operators Manual - Manual (Page 285)

OPERATION
Setting Disc Speed
Figure 4.235: Operator Console
A - Display B - Header Index C - Fast
D - Slow E - Display Selector
CAUTION
Check to be sure all bystanders have cleared the area.
Follow these steps to set the disc speed:
1. Engage header.
2. Set HEADER INDEX switch (B) to OFF.
3. Press FAST (C) or SLOW (D) on ground speed lever (GSL) until display (A) shows #### DISC RPM with desired
disc speed.
Displayed value (####) = disc speed (rpm).
169887 269 Revision A