MacDon M205 Operators Manual - Manual (Page 335)

MAINTENANCE AND SERVICING
2. Clean around the filter head (A).
3. Remove filter.
4. Clean gasket mating surface.
5. Apply a thin film of clean oil to the gasket on the
new filter. Refer to Filter Part Numbers, page 286 for
recommended oil filter to use.
6. Screw the new filter onto the filter mount until the
gasket contacts the filter head.
7. Tighten the filter an additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do NOT use a filter wrench to install the oil filter.
Overtightening can damage the gasket and filter.
8. Properly dispose of used oil filter.
Figure 5.71: Engine Oil Filter
Adding Engine Oil
1. Stop the engine and remove the key. Wait about
5 minutes.
2. Open the hood, refer to 5.4.1 Opening Hood (Lower
Position), page 288 .
3. Remove filler cap (A) by turning it counterclockwise.
4. Carefully pour in the new oil. A funnel is recommended
to avoid spillage. Refer to Lubricants, Fluids, and
System Capacities, page 285 for oil specifications.
CAUTION
Do NOT fill above the HIGH mark.
5. Replace oil filler cap (A) and turn it clockwise until snug.
6. Check the oil level, refer to Checking Engine Oil Level,
page 317 .
7. Close the hood, refer to 5.4.2 Closing Hood (Lower
Position), page 289 .
Figure 5.72: Oil Filler Cap
Air Intake System
IMPORTANT:
Do NOT run engine with air cleaner disconnected or disassembled.
169887 319 Revision A