MacDon M205 Operators Manual - Manual (Page 227)

OPERATION
12. Install the pin (B) through header leg, (engaging
U-bracket in lift linkage) on both sides and secure with
hairpin (A).
13. Raise header stand (D) to storage position by pulling
spring pin (C) and lifting stand into uppermost position.
Release spring pin (C).
Figure 4.119: Header Leg
14. Remove clevis pin from storage position (B) in linkage
and insert in hole (A) to engage float springs. Secure
with hairpin.
Figure 4.120: Header Lift Linkage
15. Disengage safety prop by turning lever (A) downward
to release and lower stop until lever locks into
vertical position.
16. Repeat for opposite safety prop.
Figure 4.121: Cylinder Stop
169887 211 Revision A