MacDon M205 Operators Manual - Manual (Page 210)

OPERATION
1. If header is attached to windrower, disconnect
center-link hook from header by pulling up on
handle (A) to release the locking device and then lifting
the hook off the header pin.
Figure 4.83: Center-Link
2. Lower the handle (A) into the LOCK position.
3. Push up on lock pin (B) only. Handle should catch on
casting and pin should NOT lift.
Figure 4.84: Center-Link Hook
A - Handle B - Lock Pin C - Actuator Rod
4. Push up on actuator rod and lock pin should lift with the
handle.
Figure 4.85: Center-Link Hook
169887 194 Revision A