Transferring r320.0 data to the r510.0 server, Transferring r320.0 data to the r510.0 server -30 – Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide User Manual
Page 114

Publication 1757-IN510A-EN-P - October 2003
4-30 ProcessLogix Server Upgrade Procedures
4. If you have a non-redundant server, enter
>NET USE T: \\PLX1\C$
/user:ps_user<
(where PLX1 is the R510.0 Server name) and press <Enter>.
5. Open Windows Explorer and verify that the T: drive exists.
6. If you have a redundant server pair,
a. On
SERVERB, enter
>NET USE T: \\PLX1B\C$ /user:ps_user<
(where PLX1B is the name of the R510.0 Backup Server)
and press <Enter>.
b. On
SERVERA, enter
>NET USE T: \\PLX1A\C$ /user:ps_user<
(where PLX1A is the name of the R510.0 Primary Server)
and press <Enter>.
c. Open Windows Explorer on each R320.0 Server and confirm
that the T: drive exists.
Transferring R320.0 Data to the R510.0 Server
1 . On the R320.0 Server(s), click Star t
⇒ Run.
2. Enter >cmd< and click OK to open the DOS window.