Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 33)

Publication 1757-IN510A-EN-P - October 2003
Operating System Installation Procedures 2-13
1 0. When all the boot floppies have been made, shut down the PC.
Starting the Windows 2000 Professional Installation from the
Boot Floppies
1 . With the PC’s power off, insert the diskette titled Windows 2000
Setup Boot Disk into the floppy disk drive.
2. Turn on the PC.
3. Insert the Microsoft Windows 2000 Professional CD into the
CD-ROM drive.
4. Follow the on-screen prompts to remove and insert the
Windows 2000 Professional Setup Disks 2, 3, and 4 when
instructed to do so.
5. Continue with Completing the Windows 2000 Professional
Installation on page 2-14.
Starting the Windows 2000 Professional Installation from the
CD-ROM
1 . Turn on the PC.
2. Insert the Microsoft Windows 2000 Professional CD into the
CD-ROM drive.
3. When prompted, enter into the computer’s BIOS setup program.
4. Verify that the Boot Priority has the CD-ROM device listed first.
(Before the floppy or hard disk devices.)
5. Exit the BIOS and save the setting.
6. Press any key to boot from the CD-ROM.
IMPORTANT
If your installation requires additional
Manufacturer’s Drivers, press <F6> during the boot
process and follow the on-screen instructions for
adding the necessary drivers.