Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 64)

Publication 1757-IN510A-EN-P - October 2003
3-2 ProcessLogix Server Installation Procedures
Installing ProcessLogix
R510.0 Software Complete the following steps to install these ProcessLogix software
components in succession.
• SQL Server
• Knowledge Builder
• RSLinx OEM 2.31 (Build 10)
• Engineering Tools
• Client/Server (Display Builder, Station, Server, etc.)
1 3. Configuring RSLinx Drivers for ControlNet Supervisory
Network
or
Configuring RSLinx Drivers for Ethernet Supervisory
Network 3-16
3-19
1 4. Completing the ProcessLogix R510.0 Setup on a
Redundant Server Pair
or
Completing the ProcessLogix R510.0 Install on a
Non-Redundant Server
6-2
3-20
IMPORTANT
PC Naming Requir ements
Before installing ProcessLogix R510.0, you must
verify that your computer name follows the PC
naming requirements. Refer to PC Naming Rules on
page 2-7.
It is strongly recommended that you name your
Server properly prior to installing ProcessLogix
R510.0 software.
To change the Server name prior to installing
ProcessLogix R510.0, follow the procedures in
Changing the Computer Name on a ProcessLogix
Client on page 8-23.
Once the ProcessLogix R510.0 software is installed,
changing the computer name requires a full uninstall
and reinstall of all the ProcessLogix R510.0 software.
Refer to Changing the Computer Name on a
ProcessLogix Server on page 8-16.
Table 3.A ProcessLogix Software Installation on a Clean PC
✔
Step Item Page