Transferring processlogix data, Transferring data to the r510.0 client, Transferring processlogix data -25 – Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide User Manual
Page 151: Transferring data to the r510.0 client -25
Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Client Installation and Upgrade Procedures 5-25
Transferring ProcessLogix
Data
Transferring Data to the R510.0 Client
1 . Logon to the R510.0 Client as ps_user.
2. Open Windows Explorer and confirm that the T: drive exists.
• If the T: drive exists, close Windows Explorer and skip
to Transfer Data on page 5-25.
• If the T: drive does not exist, close Windows Explorer and
continue with Remap the T: Drive on page 5-25.
Remap the T: Drive
3. Click Star t
⇒ Run.
4. Enter this command:
>cmd<
and click
OK to open the DOS window.
5. Enter >NET USE T: \\STN01\C$ /user:ps_user<
(where STN01 is the remote PC name and ps_user is the user
currently logged on to STN01.)
and press <Enter>.
6. If prompted, enter the appropriate password.
Transfer Data
7. Click Star t
⇒ Run.
8. Enter >cmd< and click OK to open the DOS window.
9. Enter >xcopy T:\UpgradeData\*.* C:\UpgradeData /E<
and press <Enter>.