Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 155)

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Client Installation and Upgrade Procedures 5-29
Station Setup
Setting Up a Station With a Non-redundant Server
If you are setting up Station with a redundant Server pair, refer to Setting
Up a Station With a Redundant Server Pair on page 5-31.
Complete the following steps to set up the ProcessLogix Client to
access data in a networked ProcessLogix non-redundant Server.
1 . On the Server, click Star t ⇒ Pr ograms ⇒ Pr ocessLogix
Ser ver ⇒ Start-Stop Pr ocessLogix Server to call up the
ProcessLogix Server dialog box. Verify that the Server is running
and close the dialog box.
OR
TIP
You must define the appropriate Station items in
Quick Builder on the Server in order for the Client
Station to connect.
Navigate in Knowledge Builder to Server and Client
Configuration Guide
⇒
Configuration Tutorial
⇒
Defining a Station for more information.