Configuring rslinx drivers for controlnet, Supervisory network -16 – Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide User Manual
Page 78
Publication 1757-IN510A-EN-P - October 2003
3-16 ProcessLogix Server Installation Procedures
9. Remove the Master Disk and store it in a safe place.
1 0. Restart the PC.
1 1 . If you are installing ProcessLogix software on a redundant
Server pair, return to the beginning of Moving the RSLinx
Activation File on page 3-14 and repeat for SERVERB. Otherwise,
return to the checklist that led you to this task.
Configuring RSLinx Drivers
for ControlNet Supervisory
Network
Complete the following steps to configure the ControlNet PCIC drivers
for RSLinx.
1 . Click Star t
⇒ Pr ograms ⇒ Rockwell Softwar e ⇒ RSLinx ⇒
RSLinx to call up the Rockwell Software RSLinx window.
2. Click Communications
⇒ Configur e Drivers to call up the
Configure Drivers dialog box.
3. Select 1 784-PCIC(S) for Contr olNet devices in the Available
Drivers drop-down list and click
Add New to call up the Add
New RSLinx Driver dialog box.
TIP
If you need to move the activation file back to the
Master Disk, refer to Removing the RSLinx Software
Activation File on page 4-28.
IMPORTANT
If you are using Ethernet for your Supervisory
Network, skip to Configuring RSLinx Drivers for
Ethernet Supervisory Network on page 3-19.