Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 202)

Publication 1757-IN510A-EN-P - October 2003
7-18 Firmware Maintenance Procedures
1 0. Check Yes, I w ant to launch Contr olFLASH and click Finish.
1 1 . At the Welcome to ControlFLASH window, click Nex t.
1 2. Click 1757-ABRIO and click Nex t.
1 3. Expand RSLinx Tree window to the location of the 1757-ABRIO
module you wish to flash.
1 4. Select the module icon and click OK.
1 5. Confirm that the new revision for this update is 1.2 and click
Nex t.
1 6. At the Summary window, click Finish .
1 7. Click Yes to confirm the flash.
1 8. Click OK.
If this update is successful, the Update Status window displays
the following message in green: Update Complete. Please verify
this new firmware update before using the target device in its
intended application.
1 9. Click OK and then click Cancel at the Welcome to
ControlFLASH Setup window.
20. Click Yes to end the configuration session.