Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 24)

Publication 1757-IN510A-EN-P - October 2003
2-4 Operating System Installation Procedures
1 . Insert the Windows 2000 Server CD into the CD-ROM drive.
2. Click Star t ⇒ Run.
3. Enter >cmd< and click OK to open the DOS window.
4. At the DOS prompt, enter the CD-ROM drive letter (e.g., >D:<)
and press <Enter>.
5. Enter >cd bootdisk< and press <Enter>.
6. Enter >makeboot< and press <Enter>.
7. Enter floppy disk drive letter (e.g., >A<).
8. Follow the on-screen prompts for inserting, labeling, and
creating the four floppy disks.
9. Label your floppy disks.
1 0. When all the boot floppies have been made, shut down the PC.
Starting the Windows 2000 Server Installation from the Boot
Floppies
1 . With the PC’s power off, insert the diskette titled Windows 2000
Setup Boot Disk into the floppy disk drive.
2. Turn on the PC.
3. Insert the Microsoft Windows 2000 Server CD into the CD-ROM
drive.
4. Follow the on-screen prompts to remove and insert the
Windows 2000 Server Setup Disks 2, 3, and 4 when instructed to
do so.
5. Press <Enter> at the Welcome to Setup window.
IMPORTANT
Server Boot floppies and Professional Boot floppies
are different.
IMPORTANT
If your installation requires additional
Manufacturer’s Drivers, press <F6> during the boot
process and follow the on-screen instructions for
adding the necessary drivers.