Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 39)

Publication 1757-IN510A-EN-P - October 2003
Operating System Installation Procedures 2-19
Starting the Windows XP Installation from the CD-ROM
1 . Insert the ProcessLogix R510.0 Supplemental Software CD into
the CD-ROM drive.
2. Insert a blank disk into the PC’s floppy drive.
3. Using Windows Explorer, copy the WinXP Install\winnt.sif file
from the ProcessLogix R510.0 Supplemental CD to the blank
floppy.
4. Remove the floppy disk.
5. Insert the floppy disk into the PC where XP is to be installed.
6. Turn on the PC.
7. Insert the Microsoft Windows XP Professional CD into the
CD-ROM drive.
8. When prompted, enter into the computer’s BIOS setup program.
9. Verify that the Boot Priority has the CD-ROM device listed first.
(Before the floppy or hard disk devices.)
1 0. Exit the BIOS and save the setting.
1 1 . Press any key to boot from the CD-ROM.
TIP
If you are performing a clean XP installation, steps
1–4 must be completed on a different PC.
IMPORTANT
If your installation requires additional
Manufacturer’s Drivers, press <F6> during the boot
process and follow the on-screen instructions for
adding the necessary drivers.