Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 140)

Publication 1757-IN510A-EN-P - October 2003
5-14 ProcessLogix Client Installation and Upgrade Procedures
Networking an Existing
Client to a Remote PC
Complete the following steps to map a drive on an existing Client to a
remote machine.
1 . If necessary, logon to the Client.
2. Click Star t ⇒ Run.
3. Enter >cmd< and click OK to open the DOS window.
4. Enter >NET USE T: \\STN01\C$ /user:ps_user<
(where STN01 is the remote PC name and ps_user is the user
currently logged on to STN01)
and press <Enter>.
5. If prompted, enter the appropriate password.
6. Open Windows Explorer and confirm that the T: drive exists.
7. In the DOS window, enter >xcopy C:\Data\*.* T:\UpgradeData /E<
and press <Enter>.
8. If necessary, enter >D< to specify that UpgradeData is a
directory.
Networking an Existing Client to a Remote PC is complete.
Return to the checklist that led you to this task.
ATTENTION
!
All data saved on the existing Client PC should be
stored on a remote PC before upgrading the Client.
The remote PC can be any PC on the network, such
as another Client PC.