Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 34)

Publication 1757-IN510A-EN-P - October 2003
2-14 Operating System Installation Procedures
Completing the Windows 2000 Professional Installation
1 . At the Welcome to Setup window, press <Enter>.
2. If requested, insert the Windows 2000 Professional CD into the
CD-ROM drive and press <Enter>.
3. Press <F8> to agree to the Windows 2000 Licensing Agreement.
4. If necessary, press <ESC> to continue installing a fresh copy of
Windows 2000.
5. Press <Enter> to set up Windows 2000 on the Unpartitioned
space.
6. Format the partition using the NTFS file system.
Setup formats the partition. This takes a few minutes to
complete.
The computer automatically restarts. Be sure there is not a disk
in the floppy disk drive.
7. At the Welcome to Setup window, click Nex t.
If there is a delay clicking Nex t, setup continues the installation
automatically.
IMPORTANT
If Windows 2000 Setup did not find a suitable
installation device, it stops and prompts you for
additional Manufacturer’s Drivers. Follow the
on-screen instructions for adding the necessary
drivers.
IMPORTANT
If existing partitions are found, delete all of them
first before proceeding. Use the on-screen
instructions to complete this task.
TIP
Certain PCs limit the size of the partition that you
can create. Windows 2000 supports a boot partition
size up to 32 Gigabytes on a NTFS formatted drive.
Use the entire hard disk if possible. If your system
has a limitation, create the largest partition you can,
and leave the leftover space as unpartitioned (you
can format the unpartitioned space later). The
minimum partition size required for this installation
is 4 Gigabytes.