Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 194)

Publication 1757-IN510A-EN-P - October 2003
7-10 Firmware Maintenance Procedures
Loading Boot Image
1 . Start NTools.
2. Click the desired CNB or ENET icon under the desktop tree and
wait for the graphic of the chassis to appear in the detail pane.
3. Click the 1757-PLX52, TC-MUX021, or 1757-FIM module in the
graphic of the chassis configuration in the Detail pane. If
required, select another CNB icon to find the chassis that
contains a 1757-PLX52, TC-MUX021, or 1757-FIM module.
4. Click the firmware button to initiate the firmware update.
5. Click Yes to acknowledge the Warning prompt.
6. If the LED on the 1757-PLX52, TC-MUX021, or 1757-FIM module
is not in its Ready (RDY) state, click Yes to issue a Stop
(Shutdown) command to the module and wait for the module to
reboot to its RDY state as shown in the module LED display.
Otherwise, continue with step 7.
TIP
The devices with non-compatible versions of
firmware display their firmware versions in red.
Devices with the correct version of firmware display
their firmware version in green. Unknown devices
are displayed in yellow.