Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 40)

Publication 1757-IN510A-EN-P - October 2003
2-20 Operating System Installation Procedures
Completing the Windows XP Professional Installation
1 . Press <Enter> at the Welcome to Setup Window.
2. Press <F8> to agree to the Windows XP Licensing Agreement.
3. If necessary, press <ESC> to continue installing a fresh copy of
Windows XP.
6. Press <Enter> to set up Windows XP on the Unpartitioned
space.
7. Press <Enter> to format the partition using the NTFS file system.
Setup formats the partition. This takes a few minutes to
complete.
The computer automatically restarts. Be sure there is not a disk
in the floppy disk drive.
IMPORTANT
If Windows XP Setup did not find a suitable
installation device, it stops and prompts you for
additional Manufacturer’s Drivers. Follow the
on-screen instructions for adding the necessary
drivers.
IMPORTANT
If existing partitions are found, you must delete all
of them first before proceeding.
To delete a partition:
1 . Select the partition.
2. Press <D>.
3. Press <Enter>.
4. Press <L>.
5. Repeat for all partitions.
TIP
Certain PCs limit the size of the partition that you
can create. Windows XP supports a boot partition
size up to 32 Gigabytes on a NTFS formatted drive.
Use the entire hard disk if possible. If your system
has a limitation, create the largest partition you can,
and leave the leftover space as unpartitioned. (You
can create and format the unpartitioned space
later.) The minimum partition size required for this
installation is 4 Gigabytes.