Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 96)

Publication 1757-IN510A-EN-P - October 2003
4-12 ProcessLogix Server Upgrade Procedures
4. Enter >xcopy C:\Honeywell\server\data\*.* C:\
Data\server\backup /E<
and press <Enter>.
5. If necessary, enter >D< to specify that backup is a directory.
6. Wait until the C:\ prompt appears and close the DOS window.
Removing the RSLinx Software Activation File
It is possible to transfer your RSLinx Activation codes from the old
system to the new system. Complete these steps on each Server in
your system.
To move the activation file from your Server:
1 . Insert the RSLinx Master Disk into the floppy drive.
2. Click Star t ⇒ Run.
3. Enter this path or Br ow se to:
>A: (or your floppy drive letter) \EVMOVE.EXE<
4. Click OK to launch the move executive.
5. Verify that you are Moving Activations From Drive C:
(or your hard
drive letter) to Drive A: (or your floppy drive letter) .
6. Click OK to initiate the move.
7. Click Move to move the file to the floppy.
8. Wait for a dialog box to indicate a successful move, and click
OK.