Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 43)

Publication 1757-IN510A-EN-P - October 2003
Operating System Installation Procedures 2-23
1 7. Click Nex t.
1 8. Repeat steps 15-17 for additional network cards.
1 9. At the Workgroup or Computer Domain window:
a. Select the No, this computer … option.
b. Enter an appropriate workgroup Name.
c. Click Nex t.
Setup finishes installing Windows XP. This takes some time
depending on your hardware configuration. The PC
automatically restarts.
20. If a Display Settings prompt appears, click OK, then click OK at
the Monitor Settings prompt.
21 . At the Welcome to Microsoft Windows window, click Nex t.
22. At the How will this computer connect to the internet window,
click Skip.
IMPORTANT
IP Addresses are critical to the communication of
the system. Rockwell Automation suggests, when
possible, to utilize a Private Network for the control
system. (Not connected to any other networks.)
This isolates the control system from interference
from any business communication.
In some organizations it is important for these
addresses to be controlled by the IT organization.
Consult your company’s practices and IT
organization for the appropriate IP address
information. It is necessary to use valid IP
information to integrate the ProcessLogix Control
system with the Business Network.
TIP
All systems which are configured for this Process
Control System should use the same Workgroup
Name for easier operations.
IMPORTANT
Microsoft Windows XP Professional must be
registered with the Microsoft Corporation, but
registration is not required at this time. We
recommend that you skip this step by answering
No to the activation and registration wizard.
Consult your company’s practices and IT
organization to determine proper license
acquisition.