Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 120)

Publication 1757-IN510A-EN-P - October 2003
4-36 ProcessLogix Server Upgrade Procedures
Restoring Server Redundancy
If you have a redundant Server pair, you need to restore redundancy
between the two Servers to complete the upgrade procedure.
Complete the steps to restore redundancy in Chapter 6, Additional
Redundant Server Procedures. See Table 6.A on page 6-1.
Importing the Engineering Database
Complete the steps below to import the Engineering Database. For a
redundant Server pair complete these steps on
SERVERB only.
Changing the default Operator's password
In previous releases of ProcessLogix it was not necessary to change
the default mngr operator's password to use it. As a security
precaution it is now necessary to change the password before you can
log in as the mngr operator. Only systems using operator based
security and Control Builder are affected by this change. The mngr
operator account is different than the Windows mngr user account.
Navigate in Knowledge Builder to Administration and Startup Guide
for more information before changing the password of the Windows
mngr user account.
To change the password, do the following:
1 . Logon to R510.0 Server as ps_user.
2. Click Star t ⇒ Pr ograms ⇒ Pr ocessLogix Server ⇒ Station.
3. Click the Oper field in the lower right corner of the display.
4. Enter >mngr< in the Station logon prompt and click OK.
5. Click Configur e ⇒ Operator ⇒ Operators.
6. Click the mngr Operator ID.
7. Click Change Passwor d.
IMPORTANT
If you are upgrading a redundant Server pair, you
must finish setting up redundancy before continuing.