Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 23)

Publication 1757-IN510A-EN-P - October 2003
Operating System Installation Procedures 2-3
This procedure assumes you have:
• All network cards installed in the PC and set to the correct IRQs.
• All supporting ProcessLogix System hardware installed and
connected to the PC.
• A PC that meets specified hardware and software requirements
for R510.0.
Refer to Minimum Hardware Requirements in the Preface for
more information.
• All manufacturers’ related driver diskettes available to complete
the installation.
Creating Windows 2000 Server Boot Floppies
If your system does not support booting from a CD-ROM, follow these
instructions to create the required Boot Floppies. Otherwise, skip
to Starting the Windows 2000 Server Installation from the CD-ROM on
page 2-5.
You need:
• 4 blank 3.5” 1.44 Mb (High Density) Floppy Disks
• 1.44 MB Floppy Drive
• CD-ROM Drive
• DOS or Windows based Operating System with access to
CD-ROM and floppy devices.
TIP
Consult the PC Manufacturer for any specialized
instructions/procedures related to the installation of
the Microsoft Windows 2000 Server operating system.
This procedure lists only the generic installation
procedure. It does not contain any special
instructions for any manufacturer specific driver
installation requirements.
IMPORTANT
If your installation requires additional Drivers to be
installed for access to the Hard Disk Controller, Disk
Device, or CD-ROM, it may be necessary to start the
installation via the Boot Floppies (even if your
system supports booting off of a CD-ROM).