Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 83)

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Server Installation Procedures 3-21
The message Passwor d accepted should appear in the message
zone. If it does not repeat steps 6 and 7.
Only systems using operator-based security and Control Builder
are affected by this change. The mngr operator account is
different than the Windows mngr user account. Navigate in
Knowledge Builder to Administration and Startup Guide for
more information before changing the password of the
Windows mngr user account.
8. Close Station.
9. Click Star t ⇒ Pr ograms ⇒ Pr ocessLogix Engineering Tools
⇒ Contr ol Builder.
1 0. In the Login dialog box, make these entries:
a. Enter >mngr< as the User Name.
b. Enter the appropriate Password.
c. Enter the appropriate Server name in the Server Name field.
d. Select Classic Ser ver Secur ity in the Domain Name
drop-down list.
1 1 . Click OK.
Backing Up a ProcessLogix Server Hard Drive to Tape
Performing backups is an essential part of maintaining your system.
You should back up all the files under the data directory, as well as
any user files you create. Refer to Backing Up a ProcessLogix R510.0
Server to Tape on page 8-8.
Creating an Emergency Repair Disk
After all installations and drivers are installed, you should create an
Emergency Repair Disk.
Complete the following steps to create an emergency repair disk for
your Windows 2000 Server installation.
1 . Insert a blank diskette into the PC's floppy drive.
2. Click Star t ⇒ Pr ograms ⇒ Accessories ⇒ System Tools ⇒
Backup.