Upgrade r320.0 server to r510.0, Upgrade r320.0 server to r510.0 -5 – Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide User Manual
Page 89
Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Server Upgrade Procedures 4-5
Upgrade R320.0 Server to R510.0
ProcessLogix R320.0 Server is certified to run only on Windows NT
4.0. Due to significant changes in the ProcessLogix platform, operating
system, and performance requirements, upgrading from a
ProcessLogix R320.0 Server to a ProcessLogix R510.0 Server requires
that you purchase a new PC and complete a clean R510.0 Server
installation on Windows 2000 Server.
The procedures in this section assume that:
• the old ProcessLogix R320.0 Server(s) and new ProcessLogix
R510.0 Server(s) are different PC hardware.
• the new R510.0 Server(s) is fully up and configured at this stage.
If you need to install ProcessLogix R510.0 on your Server(s),
refer to ProcessLogix Software Installation on a Clean PC on
page 3-1.
• the R320.0 and R510.0 Servers are configured on the same
network and accessible to each other. This requires that each
server has a different computer name and a unique TCP/IP
address for each network card.
Before continuing, it is recommended that you verify your R320.0 and
R510.0 Servers are properly connected using a utility like ping.
Table 4.E Upgrading R320.0 Server to R510.0 Checklist
✔
Step
Item
Page
1 .
Preparing for a ProcessLogix R320.0 to R510.0 Server
Upgrade
2.
Copying R320.0 Data to the R510.0 Server
3.
Transferring the 1784-PCIC Card to the R510.0 System
4.