Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 82)

Publication 1757-IN510A-EN-P - October 2003
3-20 ProcessLogix Server Installation Procedures
Completing the
ProcessLogix R510.0 Install
on a Non-Redundant Server Upgrading Hardware Component Firmware
1 . Refer to Loading 1757-PLX52, TC-MUX021, or 1757-FIM Boot
and Personality Images on page 7-9 to upgr ade the 1757-PLX52
boot and personality images to the current release level.
2. After upgrading the 1757-PLX52, refer to Upgrading Hardware
Component Firmware on page 7-4 to check if other hardware
components require upgrades.
Checking Control Builder Operation and Logging On
Complete the following general steps to log on and check Control
Builder operation on a ProcessLogix Server.
Changing the default Operator's password
In previous releases of ProcessLogix it was not necessary to change
the default mngr operator's password to use it. As a security
precaution it is now necessary to change the password before you can
log in as the mngr operator. To change the password, do the
following:
1 . Click Star t ⇒ Pr ograms ⇒ Pr ocessLogix Server ⇒ Station.
2. Click the Oper field in the lower right corner of the display.
3. Enter >mngr< in the Station logon prompt and click OK.
4. Click Configur e ⇒ Operators ⇒ Operators.
5. Click the mngr Operator ID.
6. Click Change Passwor d.
7. Enter the New Password, Confirm the New Password, and click
OK.
IMPORTANT
Stop! It is essential that you check the firmware
revision levels for
ALL ProcessLogix hardware
components after a ProcessLogix software
installation.
Do not proceed until you have upgr aded the
firmware.