Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 213)

Publication 1757-IN510A-EN-P - October 2003
Supplementary Procedures 8-11
5. Do the following in the Options tab.
a. Enter > 2< in the field for Delay between scans (seconds).
b. Select the Per iodic (automatic) option.
This means automatic scans are made periodically with the
specified delay between scans.
c. Check Enable Module Ver sion/Revision Checking.
This turns on the automatic firmware version/revision
detection function. This means Network Tools automatically
detects any incompatible firmware in a given module and
shows the module’s firmware indication in Red instead of
Green on the module’s graphic representation.
d. Check Enable Contr olNet Par ameter Checking.
This turns on the function for checking ControlNet parameter
settings.
6. Click OK to close the dialog box.
7. Click the resume button to initiate network scan.
8. When network nodes appear under the Desktop tree icon, click
the first CNB or Ethernet driver icon to call up the settings dialog
box.
You only have to make these settings on the initial scan of the
system. However, you can access the settings at any time by
clicking the CNB or ENET icon and then clicking Settings .