Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 87)

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Server Upgrade Procedures 4-3
Upgrade R400.0 SP2 Server to R510.0
This section describes the steps necessary to upgrade the
ProcessLogix R400.0 SP2 Server software to R510.0. There are two
upgrade options.
Option 1: Upgrading R400.0 SP2 Server to R510.0 - Clean Install
a. Backup your data.
b. Complete a clean install.
c. Restore your data.
The following table lists the items in Option 1 that you MUST
complete to upgrade an R400.0 SP2 Server to an R510.0 Server.
IMPORTANT
Due to the nature of this upgrade, it is strongly
recommended that you follow Option 1 when
upgrading from R400.0 SP2 to R510.0.
TIP
Upon restarting the system, you may receive a
message that a service failed to start. If you receive
this message, click
OK.
Table 4.C Option 1: Upgrading R400.0 SP2 Server to R510.0 Checklist
✔
Step Item Page
1 . Preparing for a ProcessLogix R400.0 SP2 or R500.1 to R510.0
Server Upgrade 4-6
2. Saving R400.0 SP2 or R500.1 Data to a Remote PC 4-13
3. Clean System Windows 2000 Server Installation 2-2
4. Windows 2000 Service Pack 4 Installation 2-29
5. Windows Security Hotfix Installation 2-31
6. Internet Explorer 6.0 SP1 Installation 2-33
7. Updating Windows Installer 2-36
8. Updating ISScript 2-37
9. Additional Operating System Customization Procedures 2-38
1 0. Creating Emergency Repair Disks 2-40
1 1 . Copying R400.0 SP2 or R500.1 Data to the R510.0 Server 4-33
1 2. Restoring ProcessLogix Data 4-35