Making first time network tools settings, Making first time network tools settings -10, Refer – Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide User Manual
Page 212
Publication 1757-IN510A-EN-P - October 2003
8-10 Supplementary Procedures
Making First Time Network Tools Settings
Complete the following steps to make the initial settings for Network
Tools the first time you launch the utility on your PC.
1 . Click Star t
⇒ Run.
a. For ControlNet Supervisory Networks, enter
>ntools -c -u -pg<.
b. For Ethernet Supervisory Networks, enter >ntools -e -u -pg<.
2. Click OK to launch the Network Tools application.
3. Click OK to acknowledge the warning about monitoring
through Control Builder.
4. With the Desktop icon selected, click Settings
to display
the Settings dialog box.
IMPORTANT
While using Network Tools, you may see a Message
Meter dialog box. Comply with the request regarding
Control Builder, if applicable, and close the dialog
box.
TIP
If RSLinx and the PCIC driver services for system
communications in ControlNet mode are not
running, this command starts the services.